Indexado en

Licencia y uso

Citaciones

Altmetrics

Análisis de autorías institucional

Carsi, ManuelAutor o Coautor

Compartir

Simulation of hot rolling processing of an Al-Cu-Mg alloy by torsion tests

Publicado en:Materials Science Forum. 706-709 277-+ - 2012-01-01 706-709(), DOI: 10.4028/www.scientific.net/MSF.706-709.277

Autores: Carreno, Fernando; Cepeda-Jimenez, Carmen M; Penalba, Felix; Carsi, Manuel; Ruano, Oscar A

Afiliaciones

Resumen

Hot torsion tests to fracture to simulate thermomechanical processing were carried out on a solution-treated Al-Cu-Mg alloy (Al 2024-T351) at constant temperature. Torsion tests were conducted to failure in the range 270 to 470 degrees C, between 2 and 26 s(-1). A peak ductility of the 2024 alloy was found at about 410 degrees C. The high temperature data was analyzed by means of a Garofalo equation, obtaining a stress exponent of 6.1 and an activation energy for deformation of 180 kJ/mol. These high temperature deformation parameters correspond to an underlying deformation mechanism of constant substructure (n=8) but experiencing increasing microstructure coarsening with increasing temperature. The workability of the alloy was characterized by maximum energy efficiency and stability maps constructed from the torsion tests data to determine optimal conditions for the forming process, which depend on applied strain rate. A forming temperature of about 400 degrees C is recommended.

Palabras clave